Cherokee 2WD L6-4.0L VIN S (1998)
Remove Fifth Gear, First Gear Bearing, And Thrust Washer
4. Using Bearing Splitter P-334 or suitable press plates positioned under first gear, press fifth gear, rear bearing, first gear, and first gear thrust
washer off output shaft.
5. Remove first gear thrust washer locating pin from output shaft.
6. Remove first gear needle roller bearing from output shaft.
7. Remove first gear spacer from output shaft.
8. Remove first gear synchronizer ring.
9. Remove select fit snap-ring holding the 1-2 synchronizer/reverse gear onto the output shaft.
Remove Second Gear And 1 - 2 Synchronizer/Reverse Gear
10. Using Bearing Splitter P-334 or suitable press plates positioned under second gear, press 1-2 synchronizer/reverse gear and second gear from
output shaft.
11. Remove second gear needle roller bearing from the output shaft or second gear.