Cherokee 2WD V6-173 2.8L VIN W 2-bbl (1986)
Clutch Master Cylinder: Service and Repair
Master Cylinder R&R
Removal
1. Disconnect the hydraulic line at the clutch master cylinder.
2. Cap the hydraulic line and the cylinder opening to prevent dirt entry.
3. Remove the cotter pin and the washer that retain the cylinder push rod on the clutch pedal and slide the rod off the pedal pivot.
4. Remove the nuts attaching the clutch cylinder to the mounting studs on the dash panel and remove the cylinder.
Installation
1. Install the clutch master cylinder on the dash panel mounting studs. Tighten the cylinder attaching nuts with the specified torque.
2. Connect the hydraulic line to the clutch master cylinder.
3. Install the master cylinder push rod on the clutch pedal pivot and install the retaining washer and cotter pin.
4. Fill the clutch cylinder reservoir with brake fluid to the level indicated on the side of the reservoir. Use AMC/Jeep brake fluid, or equivalent,
marked SAE J-1703 or DOT 3 only to fill the reservoir.