Cherokee 4WD L6-4.0L VIN S (1998)
Antenna Cap Nut Remove/Install - Typical
5. Remove the antenna cap nut and adapter using an antenna nut wrench (Special Tool C-4816).
Antenna Cap Nut Remove/Install - Typical
6. Lower the antenna body and cable assembly through the fender far enough to access the antenna body by reaching up into the rear of the right front
fender wheel opening between the right cowl side outer panel and the fender.
7. Disengage the coaxial cable grommet from the hole in the right cowl side outer panel.
8. Pull the coaxial cable out through the right cowl side outer panel.
9. Remove the antenna body and cable from the vehicle.
10. Reverse the removal procedures to install. Tighten the antenna cap nut to 7.3 N.m (70 in. lbs.). Tighten the antenna mast to 3.3 N.m (30 in. lbs.).