Cherokee 4WD L6-4.0L VIN S (1998)
New Rear Sensor
6. If new sensor was installed, push cardboard spacer on sensor face against tone ring. Then tighten sensor bolt to 13 Nm (115 in. lbs.). Correct air
gap will be established as tone ring rotates and peels spacer off sensor face.
7. Route sensor wires to rear seat area.
8. Feed sensor wires through floorpan access hole and seat sensor grommets in floorpan.
9. Verify that rear sensor wires are secured to rear brake hose and axle with clips. Verify that wire is clear of rotating components.
10. Install brake drum and wheel and tire assembly.
11. Lower vehicle.
12. Connect sensor wire to harness connector. Then reposition carpet and fold rear seat down.