Cherokee 4WD L6-4.0L VIN S (1998)
Headlamp Control Module: Testing and Inspection
Delay Function Inoperative
1. Ensure headlamps operate before proceeding.
2. Remove, inspect and test the HDLP delay 10 Amp fuse in junction box. Replace if defective.
3. With the key off and the connector disconnected, measure the resistance from the delay module terminal 4 to vehicle body ground. The ohmmeter
should indicate Zero Ohms. If not, repair the open circuit in the wire harness to vehicle body ground.
4. With the key on measure the voltage between the delay module terminal 8 and vehicle body ground. The voltmeter should indicate battery voltage.
If not, repair the open circuit in the wire harness from ignition switch to HDLP delay module.
5. Turn headlamps on and measure voltage at terminal 6. The voltmeter should indicate battery voltage. If not repair open circuit between L2 and
HDLP delay module.
6. Measure the voltage between the delay module terminal 2 and vehicle body ground. The voltmeter should indicate battery voltage. If not, repair
the open circuit in the wire harness to the HDLP fuse in the PDC.
7. If steps 1 through 6 prove out good, replace headlamp delay module.
