Cherokee 4WD L6-4.0L VIN S (1998)
Steering Column Cover: Service and Repair
REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIR-BAGS, REFER TO AIR BAGS AND SEAT BELTS/AIR BAGS BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE.
FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE
PERSONAL INJURY.
1. Disconnect and isolate the battery negative cable.
2. If the vehicle is so equipped, move the tilt steering column to the fully raised position.
Steering Column Opening Cover
3. Remove the three screws that secure the steering column opening cover to the lower instrument panel reinforcement
4. Using a trim stick or another suitable wide flat-bladed tool, gently pry the upper edge of the steering column opening cover away from the
instrument panel on each side of the steering column to release the two snap clip retainers that secure the cover to the instrument panel.
5. Remove the steering column opening cover from the vehicle.
6. Reverse the removal procedure to install. Tighten the mounting screws to 2.2 N.m (20 in. lbs.).