Cherokee 4WD L6-4.0L VIN S (1998)
Seals and Gaskets: Service and Repair
Solenoid Harness Adapter Seal
REMOVAL
1. Remove oil pan and oil screen.
Solenoid Wire Connectors
2. Disconnect solenoid wire connectors.
Harness Adapter Removal/Installation
3. Remove bracket securing solenoid harness adaptor to case.
4. Pull harness adapter and wires out of case.
5. Remove and discard adapter O-ring.
INSTALLATION
1. Lubricate new O-ring and install it on adapter.
2. Install solenoid wire harness and adapter in case.
3. Install adapter bracket and bracket bolt.
4. Connect wires to solenoids.
5. Install oil screen.
6. Apply bead of Threebond"R" Liquid Gasket T131281, P/N 83504038, to oil pan seal surface. Sealer bead should be at least 3 mm W8 inch)
wide.
7. Install oil pan on transmission. Tighten pan bolts to 7 Nm (65 inch lbs.) torque.
8. Install and tighten oil pan drain plug to 20 Nm (15 ft. lbs.) torque.
9. Fill transmission with Mopar (R) Dexron II/Mercon.
