Cherokee 4WD L6-4.0L VIN S (1998)
Install Bearing On Trunnion
3. Place a bearing cap over the trunnion and align the cap with the yoke bore. Keep the needle bearings upright in the bearing assembly. A needle
bearing lying at the bottom of the cap will prevent proper assembly.
4. Press the bearing cap into the yoke bore enough to install a snap ring.
5. Install a snap ring.
6. Repeat Step 3 and Step 4 to install the opposite bearing cap. If the joint is stiff or binding, strike the yoke with a soft hammer to seat the needle
bearings.
7. Add grease to lube fitting, if equipped.
8. Install the propeller shaft.