Cherokee 4WD L6-4.0L VIN S (1998)
Input Shaft: Service and Repair
DISASSEMBLY
1. Verify that the 3-4 synchronizer is in the neutral position.
Separate Input And Output Shafts
2. Separate input shaft from he output shaft.
3. Remove the output shaft pilot bearing from the input shaft or output shaft.
4. Remove the fourth gear synchronizer ring from the input shaft.
5. Remove the select fit snap-ring holding the input shaft bearing onto the input shaft.
6. Using Bearing Splitter P-334 and a shop press, remove the bearing from the input shaft.
ASSEMBLY
1. Position input shaft bearing onto input shaft. Be sure that the snap-ring groove in the bearing is facing forward.
2. Using Driver 6052, drive bearing onto input shaft.
