Cherokee 4WD L6-4.0L VIN S (1998)
Rear Wiper Motor Remove/Install
3. From the outside of the liftgate, remove the rear wiper motor output shaft nut.
4. Pull the rear wiper motor output shaft bezel and rubber gasket away from the liftgate far enough to access the washer supply hose.
5. Disconnect the washer supply hose from the internal nipple on the bezel.
6. Remove the bezel and rubber gasket from the motor output shaft.
7. Remove the liftgate trim panel from the liftgate.
8. Unplug the rear wiper motor wire harness connector.
9. Remove the two screws that secure the rear wiper motor mounting bracket to the liftgate inner panel.
10. Remove the rear wiper motor and mounting bracket from the liftgate as a unit.
11. Reverse the removal procedures to install. Tighten the mounting hardware as follows:
-
Rear wiper motor mounting bracket screws - 5 N.m (45 in.lbs.)
-
Rear wiper motor output shaft retaining nut - 3 N.m (27 in. lbs.).