Cherokee 4WD LHD L6-4.0L VIN S (2001)
Fig.28 Front Shoulder Belt - 4-Door Module
2. Unsnap and lift the front shoulder belt turning loop cover to access the screw that secures the turning loop to the adjuster or.
3. Remove the screw that secures the shoulder belt turning loop to the adjuster.
4. Remove the shoulder belt turning loop and the support/guide washer from the adjuster.
5. On 2-door models only, lift the lower seat belt anchor plate cover on the inner sill to access and remove the screw that secures the anchor plate to
the sill.
6. On 4-door models only, remove the inner sill trim from the sill panel.
7. On 2-door models only, remove the B-pillar lower trim from the B-pillar.
8. Remove the screw that secures the retractor (2-door models) or the retractor and lower seat belt anchor plate (4-door models) to the B-pillar.
9. Remove the front seat shoulder belt and retractor from the B-pillar.
INSTALLATION
WARNING: DURING AND FOLLOWING ANY SEAT BELT SERVICE, CAREFULLY INSPECT ALL SEAT BELTS, BUCKLES,
MOUNTING HARDWARE, AND RETRACTORS FOR PROPER INSTALLATION, OPERATION, OR DAMAGE. REPLACE ANY
BELT THAT IS CUT, FRAYED, OR TORN. STRAIGHTEN ANY BELT THAT IS TWISTED. TIGHTEN ANY LOOSE FASTENERS.
REPLACE ANY BELT THAT HAS A DAMAGED OR INOPERATIVE BUCKLE OR RETRACTOR. REPLACE ANY BELT THAT HAS
A BENT OR DAMAGED LATCH PLATE OR ANCHOR PLATE. NEVER ATTEMPT TO REPAIR A SEAT BELT COMPONENT.
ALWAYS REPLACE DAMAGED OR FAULTY SEAT BELT COMPONENTS WITH THE CORRECT, NEW AND UNUSED
REPLACEMENT PARTS LISTED IN THE MOPAR PARTS CATALOG.
