Cherokee 4WD LHD L6-4.0L VIN S (2001)
Seals and Gaskets: Service and Repair
Adapter Housing Seal Replacement
ADAPTER HOUSING SEAL
REMOVAL
1. Raise vehicle.
2. Disconnect or remove components necessary to gain access to seal (e.g. propeller shaft, crossmember, shift linkage, transfer case, exhaust
components, hoses, woes).
3. On 4X2 vehicles, remove dust shield from the adapter housing by tapping gently with a brass drift and hammer (Fig. 123).
4. On 4X2 vehicles, remove the adapter housing seal with Seal Puller 7550.
5. On 4X4 vehicles, remove the adapter housing seal using a slide hammer mounted screw.
INSTALLATION
1. Install new adapter housing seal with Seal Installer 7888.
2. On 4X2 vehicles, install dust shield using Special Tool D-187-B.
3. Reinstall components removed to gain access to seal.
4. flap off transmission.