Cherokee 4WD LHD L6-4.0L VIN S (2001)
6. Using yoke Spanner Wrench 6958 and a torque wrench set at 353 Nm (260 ft. lbs.), slowly tighten the nut (Fig. 34) in 6.8 Nm (5 ft. lbs.)
increments until the rotating torque is achieved. Measure the rotating torque with inch pound torque wrench frequently to avoid over crushing the
collapsible spacer (Fig. 35).
NOTE: If more than 353 Nm (260 ft. lbs.) torque is required to crush the collapsible spacer, the spacer is defective and must be replaced.
7. Rotating torque should be the recorded reading during removal, plus an additional 0.56 Nm (5 inch lbs.).
8. Install propeller shaft with reference marks aligned.
9. Install brake rotors, and calipers (Refer to BRAKES AND TRACTION CONTROL) .
10. Install wheel and tire assemblies.
11. Lower vehicle.