Comanche 2WD L4-150 2.5L VIN E TBI (1989)
Dimmer Switch: Customer Interest
Flash to Pass - Improper Operation
Models
1989 Cherokee, Wagoneer & Comanche
Subject
Flash To Pass Activates Low Beam Instead Of High Beam Headlamps
Index
ELECTRICAL
Date
November 21, 1988
No.
08-58-88 P-4914 (C08-65)
SYMPTOM/CONDITION
When the flash to pass feature is activated, the low beam headlamps come on instead of the high beam. This may be caused by reversed wires in the
dimmer switch connector.
DIAGNOSIS
Operate the flash to pass feature by pulling the turn signal lever toward you, with the headlamp switch in the OFF position. The high beam headlamps
should come on until the lever is released. If the low beam headlamps come on, the wires in the dimmer switch connector for the high and low beam
circuits are reversed.
FIGURE 1
REPAIR PROCEDURE
Unplug the dimmer switch connector from the switch on the lower steering column and inspect the wiring. If the wiring does not match the figure below,
remove two wires (light green and white) from the connector by inserting a small flat blade tool in the connector to release the locking tab. Reverse the
two wires and install them in the connector.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No.
08-80-18-90
. . . . . . . . . . . . .
0.2 Hrs.
FAILURE CODE:
85 - Improperly Installed Wiring