Comanche 4WD L6-242 4.0L VIN L FI (1990)
Transmission Speed Sensor: Service and Repair
Speed Sensor Rotor-Speedometer Drive Gear
Fig. 25 Speedometer drive gear
REMOVAL
1.
Raise and support vehicle.
2.
Remove components necessary to gain access to rotor and drive gear, then disconnect speedometer cable and/or speed sensor.
3.
Remove extension or adapter housing, then remove speedometer drive gear snap ring, Fig. 25.
4.
Remove speedometer drive gear and spacer (if equipped), then remove rotor by carefully prying it off output shaft with wood dowel or hammer
handle.
INSTALLATION
1.
Clean all sealing surfaces on transmission case and extension/adapter housing.
2.
Install rotor, spacer (if equipped), and drive gear on output shaft, then install drive gear snap ring, Fig. 25.
3.
Apply a bead of suitable RTV sealer to transmission case sealing surface and install extension/adapter housing bolts. Torque bolts to
specifications.
4.
Install components removed to gain access to rotor drive gear.