Commander 2WD V6-3.7L (2009)
Trunk / Liftgate Hinge: Service and Repair
Hinge - Removal
REMOVAL
NOTE: It is not necessary to remove the liftgate to replace one or both hinges. The hinges can be replaced one at a time.
1. Open and support the liftgate with a suitable prop or block.
2. Remove the liftgate support struts. See: Trunk / Liftgate Shock / Support/Service and Repair/Gas Prop - Removal.
3. Using a trim stick C-4755 or equivalent, release the retaining clips that secure the header trim molding in the liftgate opening and remove.
4. Mark the hinge (1) liftgate half location on the liftgate inner panel to aid reinstallation.
5. Remove the two screws (2) that secure the hinge to the liftgate.
