Commander 2WD V6-3.7L (2009)
1. Disconnect and isolate the battery negative cable.
2. Remove the trim panel from the liftgate (1). See: Trunk / Liftgate Interior Trim Panel/Service and Repair/Liftgate Trim Panel - Removal
3. Position the watershield aside to gain access to the latch.
4. Disconnect the electrical connectors of the latch (2).
5. Disconnect the latch cable from the liftgate handle and separate the support clips.
6. Remove the three screws (2) that secure the latch (1) to the liftgate.
7. Remove the liftgate latch (1) from the vehicle.
Latch - Installation
