Commander 2WD V6-3.7L (2009)
8. Install booster push rod (2) on pedal pin (3) and install retainer clip (1) on pedal pin.
9. Reconnect the negative battery cable.
10. Fill and bleed brake system.
11. Check and adjust stop lamp switch if necessary.
Adjustable Pedals
ADJUSTABLE PEDAL
1. Install the pedal assembly (2) to the vehicle.
2. Tighten the upper brake pedal sled nuts (4).
3. Install and tighten the 2 accelerator pedal (2) nuts to 28 Nm ( 21 ft. lbs.).
4. Reconnect the accelerator pedal cable.
5. Reconnect the pedal motor electrical connector.