Commander 2WD V6-3.7L (2009)
Brake Master Cylinder: Removal and Replacement
Brake Master Cylinder - Removal
REMOVAL
1. Siphon the master cylinder.
2. Remove the primary brake line (6) at the master cylinder.
3. Remove the secondary brake line (6) at the master cylinder.
4. Disconnect the brake fluid level switch (7) from the master cylinder.
5. Remove the 2 master cylinder mounting nuts (8).
6. Remove the master cylinder.
Brake Master Cylinder - Installation
INSTALLATION
NOTE: Bleed new master cylinder on bench before installation.
1. Install the master cylinder with new gasket and nuts (8).
2. Reconnect the brake fluid level electrical connector (7).
3. Install the secondary brake line (6) at the master cylinder.
4. Install the primary brake line (6) at the master cylinder.
5. Fill and bleed brake system.
Brake Master Cylinder Reservoir - Removal