Commander 2WD V6-3.7L (2009)
7. Using Camshaft Holder 8428 (2), rotate the camshaft until the camshaft sprocket dowel is aligned with the slot in the camshaft sprocket. Install the
sprocket onto the camshaft.
CAUTION: Remove excess oil from the camshaft sprocket bolt. Failure to do so can cause bolt over-torque resulting in bolt failure.
8. Remove excess oil from camshaft sprocket bolt, then install the camshaft sprocket retaining bolt and hand tighten.
9. Remove the Wedge Locking Tool 8379 (1).
10. Using Spanner Wrench 6958 with adapter pins 8346, tighten the camshaft sprocket retaining bolt to 122 Nm (90 ft. lbs.).
11. Install the camshaft position sensor.
12. Install the cylinder head cover. See: Cylinder Head Assembly/Valve Cover/Service and Repair/Cylinder Head Cover(s) - Installation.
