Commander 2WD V6-3.7L (2009)
Balance Shaft: Service and Repair
Balance Shaft Module - Removal
REMOVAL
1. Remove the primary and secondary timing chains. See: Timing Chain/Service and Repair/Removal and Replacement/Timing Chain & Sprockets -
Removal. NOTE: The balance shaft and gear are serviced as an assembly. Do not attempt to remove the gear from the balance shaft.
Remove the retaining bolt (4) from the balance shaft thrust plate (2).
2. Using Balance Shaft Remover/Installer 8641 (1), remove the balance shaft from the engine.
