Commander 2WD V6-3.7L (2009)
Control Assembly: Service and Repair
A/C and Heater Control - Removal
Front
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow
these instructions may result in accidental airbag deployment and possible serious or fatal injury.
NOTE: ATC A/C-heater controls are NOT interchangeable between other model years or other vehicle lines. If replacement of the A/C-heater
control is required, only use the control designed for the vehicle being serviced.
1. Disconnect and isolate the negative battery cable.
2. Remove the center bezel (1) from the instrument panel and place it on a workbench.
3. Remove the screws (2) that secure the electronic vehicle information center (EVIC) control (3) and the A/C-heater control (4) to the center bezel
and remove the controls.
Rear
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Using Trim Stick C-4755 (1) or equivalent, remove the rear A/C-heater control (2) from the bezel (3) located on the right interior quarter trim
panel (4), by releasing the retainer clips from the trim panel.