Commander 2WD V6-3.7L (2009)
Fuel Gauge Sender: Service and Repair
Fuel Gauge Sending Unit - Removal
REMOVAL
The fuel level sending unit (fuel level sensor) (3) and float assembly (7) and (8) is located on the side of the fuel pump module.
1. Remove fuel pump module from fuel tank. See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Tank/Service and Repair/Removal
and Replacement/Fuel Tank - Removal.
2. Disconnect electrical connector from fuel pump module. Record pin location first. Separate necessary sending unit wiring from connector using
terminal pick/removal tool.
3. To remove sending unit from pump module, use a small pick (5) or screwdriver. Lift on plastic locking tab (4) while sliding sending unit (3) down
the mounting tracks (6).