Commander 2WD V6-3.7L (2009)
Headlamp Bulb: Service and Repair
Front Lamp Unit Bulb - Installation
BULB - HEADLAMP
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb
life will result.
NOTE: The following procedure applies to both the low beam (upper) and the high beam (lower) headlamp bulbs. The service procedures for
each bulb are the same, only the bulb location, size and type differ.
1. Align the low beam (upper) or high beam (lower) bulb base (1) with the keyed opening on the back of the reflector.
2. Insert the bulb and base into the reflector until the base is firmly seated.
3. Rotate the base clockwise about 30 degrees to lock it into place.
4. Reconnect the pigtail wire connector to the connector receptacle integral to the bulb base on the back of the front lamp unit housing.
5. Reinstall the front lamp unit cover over the top of the lamp. See: Front Lamp Unit Boot - Installation.
6. Reconnect the battery negative cable.
