Commander 2WD V6-3.7L (2009)
EGR Valve: Service and Repair
Exhaust Gas Recirculation (EGR) Valve - Removal
REMOVAL
The electronic EGR valve and solenoid assembly (1) is attached to the rear of the left cylinder head.
1. Use a diagnostic scan tool to record any DTC's (Diagnostic Trouble Codes).
2. Disconnect and isolate the negative battery cable.
An exhaust gas routing tube (1) connects the EGR valve (4) to the intake manifold.
3. Remove two tube mounting bolts (2).
4. Remove tube (1) from solenoid (4). Slip opposite end of tube (6) from intake manifold.
5. Remove gasket (3) located between EGR valve solenoid and tube flange.