Commander 2WD V6-3.7L (2009)
Throttle Body: Service and Repair
Throttle Body - Installation
3.7L
1. Check condition of throttle body-to-intake manifold O-ring. Replace as necessary.
2. Clean mating surfaces of throttle body and intake manifold.
3. Install O-ring between throttle body and intake manifold.
4. Position throttle body (1) to intake manifold.
5. Install all throttle body mounting bolts (2) finger tight.
CAUTION: The throttle body mounting bolts MUST be tightened to specifications. Over tightening can cause damage to the throttle body or
the intake manifold.
6. Obtain a torque wrench. Tighten mounting bolts (as shown) in a mandatory torque criss-cross pattern sequence to 7.5 Nm (65 in. lbs.).
