Commander 2WD V6-3.7L (2009)
The center upper anchor (2) is integral to the second row center seat cushion frame (1). This anchor is constructed from a heavy-gauge steel wire loop
that is securely welded to the back of the center seat cushion frame. The child restraint upper center tether anchor cannot be adjusted or repaired and, if
ineffective or damaged, it must be replaced as a unit with the second row center seat cushion frame.
The lower anchors (2) are integral to the second row outboard seat cushion frames, which are secured with hinges and latches to the rear floor panel.
These anchors are each constructed from a heavy-gauge steel wire loop that is securely welded to the seat cushion frames. The child restraint lower tether
anchors cannot be adjusted or repaired and, if ineffective or damaged, they must be replaced as a unit with the second row outboard seat cushion frames.
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar(R) Parts Catalog.
