Commander 2WD V6-3.7L (2009)
Power Steering Pump: Removal and Replacement
Power Steering Pump - Removal
3.7L AND 4.7L
1. Siphon power steering reservoir.
2. Remove the cooler return hose at the reservoir.
3. Disconnect the pressure hose nut at the pump.
4. Remove the pressure hose at the pump.
5. Remove serpentine drive belt,See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and
Repair/Serpentine Accessory Drive Belt - Removal.
6. Remove 3 pump mounting bolts (1).
7. Remove pulley from pump if necessary See: Power Steering Pump Pulley - Removal.
Power Steering Pump - Installation
3.7L AND 4.7L
1. Install pulley on pump if removed See: Power Steering Pump Pulley - Installation.
2. Install 3 pump mounting bolts (1) and tighten to 28 Nm (21 ft. lbs.).
3. Install the drive belt,See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and
Repair/Serpentine Accessory Drive Belt - Installation.
4. Install the pressure hose on the pump and tighten the nut to 28 Nm (21 ft. lbs.).
5. Install the cooler return hose at the reservoir.
6. Add power steering fluid,See: Service and Repair/Power Steering System Bleeding.
Power Steering Pump Pulley - Removal