Commander 2WD V6-3.7L (2009)
4. 8 Cylinder engine only - Install the pressure and return lines (2, 3) to the steering gear (1) and tighten to 28 Nm (21 ft. lbs.).
5. 4x4 ONLY - Install the front axle or .
6. Install the front splash shield (if removed).
7. If equipped, install the front skid plate.
8. Install the oil filter drip tray (1).
9. Install the outer tie rod ends (2) to the knuckles (5) and tighten the tie rod end nuts (1) to 95 Nm (70 ft. lbs.).
10. Install the wheel and tire assembly, See: Wheels and Tires/Service and Repair/Removal and Replacement.
11. Remove the support and lower the vehicle.