Commander 2WD V6-3.7L (2009)
Seals and Gaskets: Service and Repair
Output Shaft Seal - Removal
REMOVAL
1. For 2WD transmissions;NOTE: When removing the propeller shaft flange be certain the shim remains on the output shaft.
a. Remove the propeller shaft See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Removal and
Replacement/Drive Shaft - Removal. Move propeller shaft to the right and tie up.
b. Remove the nut, with a 30 mm 12 point socket, holding the propeller shaft flange to the output shaft and remove the flange.
2. For 4WD transmissions:
a. Remove the transfer case .
b. Remove the bolts holding the transfer case adapter housing onto the transmission case. NOTE: When removing the transfer case adapter
housing be certain the shim remains on the output shaft.
c. Remove the transfer case adapter housing from the transmission case.
d. Remove the bolt holding the output shaft extension to the output shaft.
e. Remove the output shaft extension from the output shaft.
3. Remove the output shaft seal with suitable screw and slide hammer.