Commander 2WD V6-3.7L (2009)
Wiper Arm: Service and Repair
Wiper Park Ramp - Installation
INSTALLATION
1. Check to be certain that the rivet nut (4) is properly installed and in good condition in the liftgate outer panel. Replace the rivet nut, if required.
2. Position the wiper arm park ramp (5) over the rivet nut on the liftgate outer panel.
3. Install and tighten the screw (6) that secures the park ramp to the liftgate outer panel. Tighten the screw to 6 Nm (55 in. lbs.).
4. Reinstall the rear wiper arm onto the park ramp and the rear wiper motor output shaft (3). See: Wiper Arm - Installation.
