Commander 2WD V6-3.7L VIN K (2006)
2.
Attach vise grip pliers to the lower door hinge spring.
3.
Rotate the hinge spring until the end of the spring is positioned correctly.
a.
If the lower hinge is attached to the LEFT FRONT DOOR, then the hinge spring should be positioned so that its end is in the UP position.
b.
If the lower hinge is attached to the RIGHT FRONT DOOR, then the hinge spring should be positioned so that its end is in the DOWN
position.
4.
Remove the pliers from the door hinge spring.
5.
Using the appropriate touch up paint color, paint over any scratches made by the pliers to the hinge spring.
6.
Lubricate the inside diameter of hinge cam roller and the cam roller axle.
7.
Remove the temporary A-pillar paint shield.
8.
Inspect the other front door lower hinge for a chirp/squeak-like sound. If the chirp/squeak-like sound is present, perform the above repair steps.
9.
Lubricate the both rear door cam roller axles.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE
FAILURE CODE
Disclaimer
This bulletin is supplied as technical information only and is not an authorization for repair.