Commander 2WD V6-3.7L VIN K (2006)
![background image](/jeep/commander_2wd/v6-3.7l_vin_k/Page-2232001.png)
Trunk / Liftgate Hinge: Service and Repair
HINGE
NOTE: It is not necessary to remove the liftgate to replace one or both hinges. The hinges can be replaced one at a time.
REMOVAL
1. Open and support the liftgate with a suitable prop or block.
2. Remove the liftgate support struts.
3. Using a trim stick C-4755 or equivalent, release the retaining clips that secure the header trim molding in the liftgate opening and remove.
4. Mark the hinge (1) liftgate half location on the lift-gate inner panel to aid reinstallation.
5. Remove the two screws (2) that secure the hinge to the liftgate.