Commander 2WD V6-3.7L VIN K (2006)
1.
Sunroof over/under flush to the outside surface of the roof panel (Fig. 2). Fix: Adjust sunroof (glass) to obtain the following flush measurement to
the roof panel:
a.
Front edge of sunroof glass: -1.0 mm (+/- 1.0 mm). Glass range: from -2 mm (under flush) to 0 mm (flush) to roof panel.
b.
Rear edge of sunroof glass: +1.0 mm (+/- 1.0 mm). Glass range: +2 mm (over flush) to 0 mm (flush) to roof panel.
2.
Sunroof not centered in roof panel opening. Fix: Adjust sunroof module so that it is centered in opening.
3.
Sunroof-to-roof seal has gaps, appears pinched or warped. Fix: Adjust sunroof module to remove imperfections in seal.
G.
Wind Whistle-Like Sound At Front Door
Possible Cause and Solution:
1.
Front door is over/under flush to surrounding panels (Fig. 2). Fix: Adjust front door to obtain the following flush measurement with adjacent body
panel:
a.
Front Door to Roof Panel: +3.0 mm (+/- 1.5 mm). Front door range: +1.5 mm (over flush) to +4.5 mm (over flush) to roof panel.
b.
Front Door to Rear Door: 0.0 mm (+/- 1.0 mm). Front door range: -1.0 mm (under flush) to +1.0 mm (over flush) to rear door
c.
Front Door to Fender: +0.5 mm (+/- 1.0 mm). Front door range: -0.5 mm (under flush) to +1.5 mm (over flush) to front fender.
d.
Front Door to Windshield Molding: +3.0 mm (+/- 1.0 mm). Molding range: +2.0 mm (over flush) to +4.0 mm (over flush) to front door.
e.
Front Door to Fender Alignment: 0.0 mm (+/- 1.5 mm). Front door body line alignment range: - 1.5 mm (below) to +1.5 mm (above) body
line of fender.