Commander 2WD V6-3.7L VIN K (2006)
5. Pull the reservoir straight up out of the cylinder (2).
6. Remove and discard grommets from the cylinder body (2).
7. Remove the fluid level sensor (1) from the reservoir (2) if needed.
INSTALLATION
1. Install the fluid level sensor (1) into the reservoir (2) if removed.
2. Lubricate new o-rings (2) with clean brake fluid.
CAUTION: Do not use tools to install the o-rings. Tools may cut, or tear the o-rings. Install the o-rings using finger pressure only.