Commander 2WD V6-3.7L VIN K (2006)
Timing Chain: Service and Repair
Timing Chain Cover Removal and Installation
COVER - TIMING
REMOVAL
1. Disconnect the battery negative cable.
2. Drain cooling system.
3. Remove electric cooling fan and fan shroud assembly.
4. Remove radiator fan.
5. Disconnect both heater hoses at timing cover.
6. Disconnect lower radiator hose at engine.
7. Remove accessory drive belt tensioner assembly (1) -
8. Remove crankshaft damper.
9. Remove the generator.
10. Remove A/C compressor.
CAUTION: The 3.7L engine uses an anaerobic sealer instead of a gasket to seal the front cover to the engine block, from the factory. For service,
MOPAR Grey Engine RTV sealant must be substituted.
NOTE: It is not necessary to remove the water pump for timing cover removal.
11. Remove the bolts holding the timing cover to engine block.
12. Remove the timing cover.
INSTALLATION