Commander 2WD V6-3.7L VIN K (2006)
Air Duct: Service and Repair
Front Floor Distribution Ducts
Front Floor Ducts
DUCTS-FLOOR DISTRIBUTION
FRONT FLOOR DUCTS
REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING
WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE
THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO
DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE
AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND POSSIBLE PERSONAL INJURY OR DEATH.
NOTE:
-
Take the proper precautions to protect the face of the instrument panel from cosmetic damage while performing this procedure.
-
Illustration shown with instrument panel, gear selector and console duct removed for clarity.
1. Remove the instrument panel from the passenger compartment.
2. Disconnect the right front floor duct (5) and the left front floor duct (6) from the rear of the air distribution housing (4) and remove the front floor
ducts from the vehicle.
INSTALLATION