Commander 2WD V6-3.7L VIN K (2006)
1. Align the ends of the bulb (2) with the two bulb holders (1) within the vanity lamp housing.
2. Carefully press the bulb firmly and evenly into the bulb holders until it snaps into place.
3. Engage the two tabs (2) on the lower edge of the lens (3) within the bottom of the lamp housing.
4. Using hand pressure, press the upper edge of the lens over the top of the lamp housing until the two tabs (1) at the top of the lens snap into place.
5. Reconnect the battery negative cable.
