Commander 2WD V6-3.7L VIN K (2006)
8. Using a pick or small screwdriver (3), press release tab (2) to release plastic cable mount from bracket. Press on tab only enough to release cable
from bracket. If tab is pressed too much, it will be broken. Slide plastic mount (4) towards right side of vehicle to remove throttle cable from
throttle body bracket.
9. Remove throttle cable from vehicle.
INSTALLATION
1. Slide accelerator cable plastic mount into throttle body mounting bracket. Continue sliding until release tab (2) is aligned to hole in mounting
bracket.
2. Hold throttle in wide open position. While held in this position, slide throttle cable pin (1) into throttle body bellcrank.
3. Push rubber grommet (3) through opening in dash panel.
4. From inside vehicle, slide throttle cable core wire into opening (slot) in top of pedal arm.
5. Push plastic cable retainer (clip) (2) into pedal arm opening until it snaps in place.
6. Install air resonator tube to throttle body.
7. Before starting engine, operate accelerator pedal to check for any binding.