Commander 2WD V6-3.7L VIN K (2006)
Power Seat Switch: Service and Repair
SWITCH-SEAT
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the seat cushion side panel from the seat and disconnect the electrical harness connector.
3. Using a small flat bladed tool, gently release the four mounting tabs that secure the power seat switch and separate switch from trim panel.
INSTALLATION
1. Position the power seat switch on the seat cushion side panel. Gently apply pressure to the switch until the four mounting tabs that secure the
switch snap into place.
2. Connect the power seat switch electrical connector.
3. Install the seat cushion side panel on the seat.
4. Connect the battery negative cable.
5. Verify normal operation of the power seat assembly.