Commander 2WD V6-3.7L VIN K (2006)
Shifter A/T: Component Tests and General Diagnostics
ROAD TEST PROCEDURE
1. Road test the vehicle. Make fifteen to twenty 1-2, 2-3, 3-4, and 4-5 upshifts.
2. Perform these shifts from a standing start to 72 km/h (45 mph) with a constant throttle opening of 20 to 25 degrees.
3. With speeds below 40 km/h (25 mph), make five to eight wide open throttle kickdowns to 1st gear. Allow at least 5 seconds each in 2nd and 3rd
gear between each kickdown.
4. With the scan tool, read DTCs.
If any DTCs set after performing the above procedures, the repair is not complete. Refer to the appropriate category and perform the reported
symptom(s) diagnostic procedure.
If no DTCs set after performing the above procedures, the repair is complete.