Commander 2WD V6-3.7L VIN K (2006)
1. Disconnect and isolate the battery negative cable.
2. Remove the Center High-Mounted Stop Lamp (CHMSL) from the liftgate outer panel.
3. Disconnect the rear washer supply hose from the barbed nipple (4) on the back of the rear washer nozzle.
4. From the back of the CHMSL housing, depress the integral latch feature (2) of the nozzle, while pushing downward on the nozzle nipple.
5. Disengage the nozzle alignment pins (3) from the receptacle (1) integral to the back of the CHMSL lens and remove the nozzle.
INSTALLATION
1. Position the nozzle into the receptacle (1) integral to the back of the CHMSL lens with the alignment pins (3) on the nozzle engaged in the
saddle-like formations on each lower side wall of the receptacle.
2. Using hand pressure, press the nozzle nipple (4) upward firmly and evenly into the receptacle until the integral latch feature (2) is fully engaged on
the back of the CHMSL lens.
3. Reconnect the rear washer supply hose to the barbed nipple of the nozzle.
4. Reinstall the CHMSL onto the liftgate outer panel.