Commander 2WD V8-4.7L Flex Fuel (2009)
Trunk / Liftgate Motor: Service and Repair
Power Liftgate Drive Unit - Removal
REMOVAL
1. Open the liftgate.
2. Disconnect and isolate the battery negative cable.
3. Remove the link rod assembly from the liftgate attachment point, See: Power Liftgate Link Rod - Removal.
4. Remove the left rear D-pillar trim panel from the vehicle, See: Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar Trim/D-Pillar
Trim/Removal.
5. Remove the left quarter trim panel, See: Interior Moulding / Trim/Trim Panel/Service and Repair/Luggage Compartment Trim/Quarter Trim Panel
- Removal.
6. Disconnect the wire harness connector from the power liftgate drive unit assembly (1).
7. Remove the drive unit assembly retaining bolts (5).
8. Remove the drive unit assembly retaining nut (4).
9. Unhook the drive unit assembly (1) from the D-pillar (2) and remove the unit from the vehicle.