Commander 2WD V8-4.7L Flex Fuel (2009)
1. Disconnect and isolate the negative battery cable.
2. On LHD models, remove the glove box from the instrument panel See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service
and Repair/Instrument Panel Glove Box - Removal.
3. On RHD models, remove the instrument panel silencer from the driver side of the instrument panel.
4. Remove the three screws (1) that secure the blend door actuator (2) to the right side of the HVAC air distribution housing (3).
5. Remove the blend door actuator from the air distribution housing and disconnect the HVAC wire harness connector (4) from the actuator.
6. Remove the blend door actuator from the vehicle.
Rear
REMOVAL
1. Remove rear HVAC housing (1) and place it on a workbench .
2. Disconnect the rear HVAC wire harness connector (2) from the rear blend door actuator (3).
3. Remove the two screws (4) that secure the rear blend door actuator to the back of the rear HVAC housing and remove the actuator.