Commander 2WD V8-4.7L Flex Fuel (2009)
1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system See: Service and Repair/Refrigerant System Recovery.
3. Drain the engine cooling system See: Engine, Cooling and Exhaust/Cooling System/Service and Repair.
4. Remove the front floor console See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Floor Console - Removal.
5. Remove the instrument panel See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel -
Removal.
6. Disengage the push-pin retainer (1) that secures the front console duct (2) to the gear selector (3).
7. Disconnect the front console duct from the air distribution housing (4) and remove the console duct.
8. Remove the screws (5) that secure the gear selector to the floor panel (6) and position the gear selector out of the way.
9. Disconnect the left rear floor duct (1) and the right rear floor duct (2) from the rear floor distribution duct (3).
10. Disconnect the rear floor distribution duct from the air distribution housing (4) and remove the distribution duct.
11. Disconnect the right front floor duct (5) and the left front floor duct (6) from the air distribution housing and remove the floor ducts.