Commander 2WD V8-4.7L Flex Fuel (2009)
Compass: Removal and Replacement
Compass Module - Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Partially remove the headliner (1) to gain access to the Remote Compass Module (RCM) (2). See: Body and Frame/Interior Moulding /
Trim/Headliner/Service and Repair/Headliner - Removal for the appropriate procedure.
3. Disconnect the RCM electrical connector (3).
4. Remove the RCM retaining screws (4).
5. Remove the RCM (2) from the vehicle.
Compass Module - Installation
INSTALLATION
1. Position the Remote Compass Module (RCM) (2) into the bracket on the upper side of the headliner (1).
2. Install the RCM retaining screws (4).
3. Connect the electrical connector (3).
4. Install the headliner assembly, See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Headliner - Installation.
5. Connect the battery negative cable.
6. Perform the Compass Variation Adjustment, See: Oil Change Reminder Lamp/Service and Repair.
7. Perform the Compass Calibration, See: Oil Change Reminder Lamp/Service and Repair.
8. Verify proper compass operation.
