Commander 2WD V8-4.7L Flex Fuel (2009)
rear side marker (5). For export market vehicles they are: turn signal (2), park/stop (3), park (4) and backup (5). The service procedures for
each bulb are the same, only the bulb sizes and types may differ.
1. Align the base of the bulb with the appropriate lamp socket (2, 3, 4 or 5).
2. Push the bulb straight into the socket until the base is firmly seated.
3. Align the socket and bulb with the keyed opening on the back of the rear lamp unit (1) housing.
4. Insert the socket and bulb into the housing until the socket is firmly seated.
5. Rotate the socket clockwise about 30 degrees to lock it into place.
6. Reinstall the rear lamp unit onto the end of the quarter panel. See: Brake Lamp/Service and Repair/Tail Stop Turn Lamp - Installation.
7. Reconnect the battery negative cable.
Front Lamp Unit Bulb - Removal
BULB - PARK/TURN SIGNAL
1. Disconnect and isolate the battery negative cable.
2. Raise and support the vehicle.
3. Reach into the front wheel house ahead of the front wheel to unsnap and lift the cover over the access hole in the front of the wheel house splash
shield.
4. Reach through the access hole in the splash shield to access the park/turn signal bulb socket (5) on the bottom of the front lamp unit housing.
5. Firmly grasp the socket on the bottom of the front lamp unit housing and rotate it counterclockwise about 30 degrees to unlock it.
6. Pull the socket and bulb straight out from the keyed opening in the housing.
7. Pull the base of the bulb straight out of the socket.
Front Lamp Unit Bulb - Installation
BULB - PARK/TURN SIGNAL
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.