Commander 2WD V8-4.7L Flex Fuel (2009)
If a CM2100 PCM/ECM (6.7l) was replaced, perform the following additional steps and/or routines:
1. PCM/ECM Replaced - if WIN equipped
2. Check PCM/ECM VIN - if NOT WIN equipped
3. Enable / Disable Vehicle Features - need to enable features
4. Injector Quantity Adjustment
5. Reset Regenerative Filter Timers
6. Mobile DeSoot - NO Minimum Required Soot Load
If an Aisin TCM was replaced, perform the following additional steps and/or routines:
If an EATX TCM was replaced, perform the following additional steps and/or routines:
If an NGC3 TCM ONLY was replaced, perform the following additional steps and/or routines:
If an NGC4 TCM ONLY was replaced, perform the following additional steps and/or routines:
1. Quicklearn
If an EGS TCM was replaced, perform the following additional steps and/or routines:
1. Initialize EGS
STEP-BY-STEP INSTRUCTIONS
Check PCM/ECM VIN
From the "Home" screen, select "ECU View"
-
Select "PCM/ECM"
-
Select "Misc. Functions"
-
Select "Check PCM/ECM VIN" and follow the on screen instructions.
-
When complete, select "Finish"
Diesel Particulate Filter (Used) Learning
From the "Home" screen, select "ECU View"
-
Select "PCM/ECM"
-
Select "Misc. Functions"
-
Select "Diesel Particulate Filter (Used) Learning" and follow the on screen instructions.
-
When complete, select "Finish"
ECU Replacement with Value Transfer
From the "Home" screen, select "ECU View"
-
Select "PCM/ECM"
-
Select "Misc. Functions"
-
Select "ECU Replacement with Value Transfer" and follow the on screen instructions.
-
When complete, select "Finish"
ECU Replacement without Value Transfer
From the "Home" screen, select "ECU View"
-
Select "PCM/ECM"
-
Select "Misc. Functions"
-
Select "ECU Replacement without Value Transfer" and follow the on screen instructions.
-
When complete, select "Finish"
Enable / Disable Vehicle Features
From the "Home" screen, select "ECU View"