Commander 2WD V8-4.7L Flex Fuel (2009)
Power Trunk / Liftgate Control Module: Service and Repair
Power Liftgate Control Module - Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the left quarter trim panel from the vehicle, See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Luggage
Compartment Trim/Quarter Trim Panel - Removal.
3. Disconnect the wire harness connectors (3) from the power liftgate control module (1).
4. Remove the power liftgate control module (1) from the left rear wheel well (2).
5. Remove the module (1) from the vehicle.