Commander 2WD V8-4.7L VIN P Flex Fuel (2007)
1. Position the power sunroof motor/module (1) in the vehicle.
2. Install the motor/module retaining screws (3). Tighten the screws to 4 Nm (35 in. lbs.).
3. Connect the motor/module electrical connector (2).
4. Partially install the vehicle headliner and connect all remaining sunroof electrical connectors.
5. Connect the battery negative cable.
6. Perform the sunroof position calibration.
7. Perform the Motor/Module Initialization Procedure.
8. Complete the vehicle headliner installation.
9. Verify proper operation of the power sunroof system.
